4-Panel HUB for DN 70 with quick fastening / long version / 12mm
- A HUB serves as a holder for the grinding and polishing panels with quick fastening for a HUB set.
The HUB set is used to cleanly grind and polish pipes, as well as to grind or polish side inlets. - Suitable for 12 mm shaft for use with 12 mm FluviCutter units.
- The HUB is equipped with 4 panels with quick-release fasteners.
- Suitable for DN70 pipes.
- Diameter HUB 35 mm
- Suitable for this HUB:
-Grinding panel for DN70 with quick fastening for 4-panel HUB
-Polishing panel for DN70 with quick fastening for 4-Panel HUB
(Shown below for parts/spare parts) - Material: stainless steel
- Processing: turned / milled
- Scope of delivery: HUB incl. screws for mounting on the shaft.
- The “HUB-DISC without hole 35mm for 4-Panel HUB” to secure the panels must be ordered separately. (Shown below for components/spare parts).
In stock
Additional information
4-Panel-Hubs | DN100 (12,5 x 40 x 100), DN150 (12,5 x 40 x 150), DN200 (12,5 x 40 x 200), DN70 (12,5 x 35 x 75), DN70 kurz (12,5 x 35 x 50), DN70 kurz (8,5 x 35 x 50) |
---|
You may also like…
-
Grinding panel for DN70 with quick fastening for 2-/4-panel HUB (75x125mm)
3,58€
Plus 19% VATplus shippingDelivery Time: not specified -
HUB DISC without hole Ø35mm for 4-panel HUB
13,25€
Plus 19% VATplus shippingDelivery Time: not specified -
Grub screw 6×10 mm for 4-panel HUB
0,35€
Plus 19% VATplus shippingDelivery Time: not specified