4-Panel HUB for DN100 / with quick mounting / 12mm
65,00€
A HUB serves as a holder for the grinding and polishing panels with quick fastening for a HUB set.
Depending on the panel, the HUB set can be used to cleanly grind, grind and polish pipes and side inlets.
- Suitable for 12 mm shaft for use with FluviMiller units.
- The HUB is equipped with 4 milling panels with quick-release fasteners.
- Suitable for DN 100 pipes.
- Diameter HUB 40 mm
- Suitable for this HUB:
- Grinding panel for DN100 with quick fastening for 4-Panel HUB
- Polishing panel for DN100 with quick fastening for 4-panel HUB / short
- Polishing panel for DN100 with quick fastening for 4-panel HUB / long
(Shown below for parts/spare parts) - Material: stainless steel
- Processing: turned / milled
- Scope of delivery: HUB incl. screws for mounting on the shaft.
- The “HUB-DISC without hole 40mm for 4-Panel HUB” to secure the panels must be ordered separately. (Shown below for parts/spare parts)
In stock
Additional information
4-Panel-Hubs | DN100 (12,5 x 40 x 100), DN150 (12,5 x 40 x 150), DN200 (12,5 x 40 x 200), DN70 (12,5 x 35 x 75), DN70 kurz (12,5 x 35 x 50), DN70 kurz (8,5 x 35 x 50) |
---|
You may also like…
-
Grinding panel for DN100 with quick fastening for 4-panel HUB (100x150mm)
4,58€ -
Polishing panel for DN100 with quick fastening for 4-panel HUB / short (100x125mm)
7,97€ -
HUB DISC without hole Ø40mm for 4-panel HUB
13,25€ -
Polishing panel for DN100 with quick fastening for 4-panel HUB / long (100x150mm)
8,98€ -
Grub screw 6×12 mm for 4-panel HUB
0,35€