4-Panel HUB for DN150 with quick mounting / 12mm
- The HUB serves as a holder for the grinding and polishing panels for the HUB set with quick-release fastener.
- The HUB set is used to cleanly grind and polish pipes, as well as to grind or polish side inlets.
- Suitable for 12 mm shaft for use with Maxi Miller units.
- In the HUB 4 panels with quick-release fasteners are used.
- Suitable for DN150 pipes.
- Diameter HUB 40 mm
- Suitable for this HUB:
-Grinding panel for DN150 with quick fastening for 4-panel HUB
-Polishing panel for DN150 with quick fastening for 4-Panel HUB
(Shown below for parts/spare parts) - Material: stainless steel
- Processing: turned / milled
- Scope of delivery: HUB incl. screws for mounting on the shaft.
- The “HUB-DISC without hole 40mm for 4-Panel HUB” to secure the panels must be ordered separately. (Shown below for components/spare parts)
In stock
Additional information
4-Panel-Hubs | DN100 (12,5 x 40 x 100), DN150 (12,5 x 40 x 150), DN200 (12,5 x 40 x 200), DN70 (12,5 x 35 x 75), DN70 kurz (12,5 x 35 x 50), DN70 kurz (8,5 x 35 x 50) |
---|
You may also like…
-
HUB DISC without hole Ø40mm for 4-panel HUB
13,25€
Plus 19% VATplus shippingDelivery Time: not specified -
Grinding panel for DN150 with quick fastening for 4-panel HUB (150x200mm)
5,42€
Plus 19% VATplus shippingDelivery Time: not specified -
Polishing panel for DN150 with quick fastening for 4-panel HUB (150x200mm)
11,75€
Plus 19% VATplus shippingDelivery Time: not specified -
Grub screw 6×12 mm for 4-panel HUB
0,35€
Plus 19% VATplus shippingDelivery Time: not specified