4-Panel HUB for DN70 / with quick mounting / short version / 12mm
55,00€
- A HUB serves as a holder for the grinding and polishing panels with quick fastening for a HUB set.
- The HUB set is used to cleanly grind and polish pipes, as well as to grind or polish side inlets.
- Suitable for 12 mm shaft for use with FluviMiller units.
4 grinding panels with quick fastening are used in the HUB. - Suitable for DN 70 pipes.
- Diameter HUB 35 mm
- Suitable for this HUB:
-Grinding panel for DN50/70 short with quick fastening for 2/4-panel HUB
-Polishing panel for DN 50/70 short with quick fastening for 2/4-panel HUB - Material: stainless steel
- Processing: turned / milled
- Scope of delivery: HUB incl. screws for mounting on the shaft.
- The “HUB-DISC without hole 35mm for 4-Panel HUB” to secure the panels must be ordered separately. (Shown below for components/spare parts).
In stock
Additional information
| 4-Panel-Hubs | DN100 (12,5 x 40 x 100), DN150 (12,5 x 40 x 150), DN200 (12,5 x 40 x 200), DN70 (12,5 x 35 x 75), DN70 kurz (12,5 x 35 x 50), DN70 kurz (8,5 x 35 x 50) |
|---|
